Kingfisher CLCH60LKSS Manual De Instrucciones página 69

04 Controlling the cooker hood from your hob
Ensure the hob and hood connectivity has been completed and the Hood connection button is ON!
1. Make sure that the hob and the hood are switched off.
2. After around ten seconds, turn on the hob, press the Timer icon
control panel. The LED display will alternately flash red and white.
3. Turn on the hob and make sure the connectivity indicator is lit.
NOTE: Touch the connectivity key on the hob if it is not lit.
4. Press the two front cooking zone keys together on the hob and the connection indicator will flash to
confirm connection.
5. The control panel of the hood will show "A"for five seconds to indicate connectivity has been made with
the hob.
6. Press the two front cooking zone keys together on the hob before "A" disappears to store the
connectivity settings.
IMPORTANT: THE EXTRACTION RATE OF THE HOOD WILL VARY BASD
UPON THE TOTAL POWER OUTPUT SELECTED ON THE HOB, AS SHOWN IN
THE TABLE BELOW.
EACH HOB COOKING ZONE HAS A MAXIMUM RATED OUTPUT OF 10
COMPRISING 1-9 AND BOOST (10).
Speed Level of the Hood
Speed 1
Speed 3
Speed 5
Speed P – Boost
NOTE: Speed 2 and Speed 4 on the hood are not available when using this function.
If the hood controls are manually overridden when the hob and hood are linked, the hood will operate for five
minutes on this manual setting before returning to control by the hob.
To reconnect the hood and hob immediately, press the Timer
05 Stopping the connectivity function
1. Touch the connectivity key on the hob, the indicator light will go out and the link will be dropped. To
reconnect again, press the connectivity key on the hob again.
2. If the hob is switched off, the hood will continue to operate independently in Timer mode and the current
speed will flash. The current speed level of the hood will continue for 5 minutes and step down for 2
minutes at each level until finally switching off.
5059340446189_MNL_IN_V03.indb 68 5059340446189_MNL_IN_V03.indb 68
Combined Power Output of the Hob
This speed will be selected when there are no more than two cooking
zones in use, and the combined output is 8 or less. For example, zone 1 is
on 2, and zone 2 is on 5.
This speed will be selected when there are no more than three cooking
zones in use, and the combined output is between 9 and 24. For example,
zone 1 is on 7, zone 2 is on 6 and zone 3 is on Boost (10).
This speed will be selected when all four cooking zones are in use, or the
combined output is between 25 and 35. For example, zone 1 is on 7, zone
2 is on 7, zone 3 is on 6 and zone 4 is on Boost (10).
This speed will be selected when more than 3 cooking zones are in use,
and combined output is 36 or higher.
68
and Light icon
and Light together.
together on the
8/6/2022 3:27 PM 8/6/2022 3:27 PM