Publicidad
Idiomas disponibles
Idiomas disponibles
Air Outlet Connection
CAUTION
• We recommend using fast couple
hoses to easily get them connected to the included
nipple. This way it can be connected and disconnected
tools fast and interchange easily.
• Remove the plastic cap covering the air inlet in the
handle base.
• Screw the included nipple to the air inlet
• Connect the air hose via the quick-connect nipple.
Rotation Direction and Torque Selection
• The direction of rotation is adjusted with the torque
selector.
• To tighten a nut or lug, push the rotation selector and
turn clockwise (F). To loosen, push the rotation selector
and turn counter-clockwise (R).
• To select the torque and avoid overtightening a nut or
stud, turn the knob to the left (F) or right (R) to the desired
torque level.
• It is recommended to use the maximum torque, in case
of not having a torque wrench to verify the proper torque.
• The torque value may vary depending on the size of the
air compressor and the amount of cubic feet (CFM) of air
delivered.
Turning ON
• Turn the air compressor ON and allow it to get filled.
• Regulate the air compressor outlet pressure to 90 PSI to
110 PSI.
WARNING
• The tool operates with this pressure
range. If operating in a higher pressure range the tool
useful life will be shorter.
• Let run some air through the hose and coupling to verify
both are clean before connecting into the tool.
• Select the adequate rotation direction and torque.
• Press the trigger so that the die can rotate.
• Release the trigger to stop the die.
Operation
• Set the die in the nut or lug you want to loosen or
tighten.
• Do not try to make contact with the nut or lug with the
die moving. Do not press the trigger unless the nut or lug
is set correctly inside the die.
• Apply firm and constant pressure without forcing the
tool. Otherwise it can be damaged.
8
ENGLISH
Start Up
Air Inlet
Nipple
Stopper to secure
the fast couple
into the air hose
Rotation
selector
Trigger
Plastic
Cap
Publicidad
