Sony XR-CA300 Manual De Instrucciones página 22

Troubleshoot ing guide
The following checklist will help you remedy the problems you may encounter with your unit.
Before going through the checklist below, check the connections and operating procedures.
General
Problem
No sound.
The contents of the memory
have been erased.
Indications do not appear
in the display.
Tape playback
Problem
The sound is distorted.
Radio recept ion
Problem
Preset tuning is not possible.
Automatic tuning is not
possible.
The stations cannot be
received.
The sound is hampered by
noises.
The "ST" indication flashes.
22
Downloaded from:
Cause/Solut ion
•Cancel the ATT function (page 15).
•Set the fader control to the centre position for two-speaker
•Adjust the volume with (+).
• The power cord or battery has been disconnected.
• The RESET button was pressed.
Remove the front panel and clean the connectors. See
"Cleaning the connectors" (page 19) for details.
Cause/Solut ion
The tape head is contaminated.
t Clean the head with a commercially available dry-type
Cause/Solut ion
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
•The broadcast signal is too weak.
•The local seek mode is set to ON.
Connect an power aerial control lead (blue) or accessory power
supply lead (red) to the power supply lead of a car's aerial
booster. (When your car has built-in FM/MW/LW aerial in the
rear/side glass only.)
•Tune in the frequency accurately.
•The broadcast signal is too weak.
https://www.usersmanualguide.com/
systems.
t Store again into the memory.
cleaning cassette.
t Use manual tuning.
t Set the local seek mode to OFF (page 9).
t Set to MONO mode (page 9).