Emos P5603R Manual De Instrucciones página 8

3. The thermostat now has an active screen and is operational.
If the thermostat is not working properly, please check the polarity of the
batteries and whether they are sufficiently charged, or reset the thermostat
by removing and reinserting the batteries.
If appears on the screen, replace the batteries in the thermostat.
Setting Temperature
To increase temperature, turn the wheel right.
To reduce temperature, turn the wheel left.
The set temperature will be shown on the screen for 5 seconds, then the
room temperature will be shown instead.
Choosing Operating Mode
Unscrew the rear cover of the thermostat.
There is a DIP switch on the back of the thermostat which is used to set
the following functions.
Available Functions in HEATING Mode
cooling mode off
CHRONO mode off
6 cycles/h
°F unit of temperature
CHRONO (TPI) Mode
CHRONO mode, also known as TPI (Time Proportional and Integral) is an
algorithm that has a simple memory capable of „learning" how to reach
and maintain room temperature. It has a basic calculating capability: It
uses collected data and current temperatures and predicts how long heat
needs to be generated (the boiler must remain on). It is a type of intelligent
control, since heat delivery lasts until the desired value is reached, then
the boiler is turned off to improve energy efficiency.
1
2
3
4
8
ON heating mode on
CHRONO mode on
3 cycles/h
°C unit of temperature