Etac KI Mobility FOCUS CR Manual De Instrucciones Y Garantía página 33

Idiomas disponibles

IV. WHEELCHAIR USE & CONFIGURATION

S. Tilt Mechanism (Continued)

Using the Foot Operated Tilt

1. Tilting the Seat Frame

a. Depress the foot pedal (Fig. 23:D).

b. Rotate the seat frame to the desired position while keeping the pedal depressed.

c. Release the pedal to lock into place.

2. Adjusting the Linkage

a. Loosen the hex bolt (Fig. 23:B) on the shaft clamp (Fig. 23:C) with an 8mm wrench.

b. Slide the shaft clamp up against the drive rod linkage (Fig. 23:A) and retighten shaft clamp.

Fig. 23

Using the Tilt Stops

1. Place the tilt stop pads (Fig. 24:A) on both sides of each rotary frame (Fig. 24:B) at the

desired location. Pads should nest together.

2. Place the thrust plates (Fig. 24:C) into the pockets on the pads.

3. Insert and tighten the screw (Fig. 24:D) with the nut and the washer to lock into place.

4. To change the location of the tilt stops, remove the tilt stops and reassemble according to the

instructions above at the new desired location.

Fig. 24