Etac KI Mobility FOCUS CR Manual De Instrucciones Y Garantía página 31

Idiomas disponibles

IV. WHEELCHAIR USE & CONFIGURATION

S. Tilt Mechanism

WARNING: Do not leave an occupied chair unattended with the triggers secured in an

unlocked position. Leaving someone in a chair unattended with the triggers secured in an

unlocked position could cause a tip-over resulting in serious injury or death.

How to Use the Hand Operated (Trigger) Tilt

1. Tilting the Seat Frame

a. Squeeze the trigger (Fig. 20:A).

b. While keeping the triggers depressed, rotate the seat frame to the desired position.

c. Release the trigger to lock into place.

2. Adjusting the Tilt Cable

a. Unlock the jam nut (Fig. 20:C) from the cable adjuster body (Fig. 20:D) using a 10mm and

3/8" open ended wrench.

b. Thread the cable adjuster (Fig. 20:B) in or out until the slack in the cable is eliminated, but

also so the cogs are still fully seated in the teeth of the rotary frames.

c. Verify the function of the cable. The tilt mechanism should lock at all locations and cogs

should not drag along the teeth at any location. If the cogs drag or if there is excessive

play in the triggers, the cable adjuster must be unthreaded more. If the cog is disengaged

from the teeth at all, the adjuster must be threaded onto the body further.

d. Once the cable is adjusted and the function is verified, lock the jam nut against the cable

adjuster body by tightening the nut only, not the adjuster or the adjuster body.

Fig. 20