Etac KI Mobility FOCUS CR Manual De Instrucciones Y Garantía página 43

Idiomas disponibles

IV. WHEELCHAIR USE & CONFIGURATION

BB. Power Tilt

The Focus Power Tilt uses a Reac RCB10 battery and interface control box when operating with

adaptive switches. The Reac Control Box - RCB10 is a compact and flexible 4 channel control

box with a 2 Ah battery pack and an external charger. The RCB10 is designed to comply with

standards for powered wheelchairs (EN 12184) and assistive products (EN 12182). See Fig. 35.

Fig. 35

Charging

Cable Port

Interface Control Box Mounting

Mount the interface control box and cable in a location that the cable will not be pinched, cut,

trapped by moving components or obstruct tilt movement. The interface control box must be

close enough to the battery so that the cable is not stretched or pulled free. Ensure cable is not

exposed to being caught or snagged by any other objects.

Connecting Adaptive Switches to Interface Control Box (See image above)

For a single switch, connect the single switch interface cable to port three on the interface

control box. For a dual switch, connect the two dual switch interface cables to port one and two

of the interface box. Route the adaptive switch cable(s) so it will not be pinched, cut, trapped by

moving components or obstruct tilt movement. Ensure there is enough slack in the cable(s) so

they are not stretched or pulled free from the interface control box or mounting location.

NOTE: The interface control box cable accepts a 3.5mm / 1/8" mono phono jack.

WARNING: Ensure hand control box and cables are secure and out of the way of any

moving parts to prevent possible damage and/or a possible fall which can result in injury

or death.

Battery

THIS INTERFACE CONTROL

BOX CABLE MUST BE

Interface

USED.

Control

Box Cable

EXAMPLE:

Single Switch

Interface Cable Wiring

Port 1 - Single Direction (Dual Switch)

Port 2 - Opposite Direction (Dual Switch)

Port 3 - Toggles Direction (Single Switch)

Port 4 - Alternate / Attendant Control

Port 5 - Input to Control Box

Interface Control Box Ports