Etac KI Mobility FOCUS CR Manual De Instrucciones Y Garantía página 45

IV. WHEELCHAIR USE & CONFIGURATION
BB. Power Tilt (Continued)
3. Allow the chair to settle into position and read the angle measurement on the rotary frame.
See Fig. 38.
4. The chair should settle around 20°, if not, the seat frame set up needs adjustment.
5. If the chair does settle around 20°, reinsert the motor disconnect pin.
WARNING: Ensure the motor disconnect pin is fully engaged before attempting a transfer.
Failure to comply with the instruction above could result in serious injury or death.
Toggle Switch Hand Control Use
1. Ensure hand control toggle switch and the motor are connected to the battery before use.
See Fig. 39.
Fig. 39
Extension Cable for Charging
Fig. 38
Read
here
Motor
Hand Control Toggle Switch
44