Operation; To Adjust The Seat; To Engage And Disengage The Drive System - Jonsered FR 2213 MA Manual De Usuario

Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To fill fuel
WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
on page 9 ).
WARNING: Do not use the fuel tank as a
support area.
CAUTION: Incorrect type of fuel can result in
engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.

To adjust the seat

The seat can be tilted forward. It can also be adjusted
lengthways. Loosen the handles below the seat to adjust
it forward or rearward.
To engage and disengage the drive
system
To move the product with the engine off, the drive
system must be disengaged. Pull out the drive system
lever fully to disengage the drive on the axle. Push the
12

Operation

drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The drive system lever for model FR 2213 MA,
FR 2216 MA is found behind the left rear wheel. Model
FR 2216 MA 4X4 has one drive system lever for the
front and one for the rear axle. The drive system lever
for the rear axle is found behind the left rear wheel.
Fuel safety
The drive system lever for the front axle for
FR 2216 MA 4X4 is found behind the left front wheel.
To lift and lower the cutting deck
• To lift the cutting deck to transport position, pull the
lift lever rearward. If the engine is on, the blades stop
to rotate automatically.
826 - 001 -