Jonsered FR 2213 MA Manual De Usuario página 15

Maintenance
Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
To clean the product on page 16
Clean as given in
Clean the inner surface of the cutting deck, around the blades
Clean around the muffler
Make sure that the cold air intake of the engine is not blocked
Make sure that the safety devices are not defective
Examine and do a test of the brakes
Do a check of the engine oil level
Do a check of the oil level in the transmission
Do a check of the steering wires
Examine the blades in the cutting deck
Clean the cutting deck, below the belt covers and below the cutting
deck
Make sure that the tire pressure is correct
Do a check of the parking brake
Replace the engine oil
Replace the oil filter
Clean the air filter
Replace the air filter
Replace the fuel filter
Replace the spark plug
Do a check of the parallelism of the cutting deck
Lubricate the belt adjuster.
Examine and adjust the steering wires
Examine the muffler and heat deflector
Examine the cutting deck for damages
Adjust the parking brake.
Do a check of and adjust the throttle wire
Clean the cooling fins on the engine and the transmission
Clean the engine and the transmission
Do a check of/adjust front and rear wheel speed, FR 2216 MA 4X4
model only
Do a check of the belts
826 - 001 -
Daily maintenance
before operation
*
*
X
X
X
X
X
*
X
X
X
Maintenance interval
in hours
25 50 100 200
X
X
X X
X
X X
X X
X
X
X
X
X X
X X
O O
O
O
O
O
O
O
O O
O O
15