To Apply And Release The Parking Brake; To Stop The Engine; Maintenance; Maintenance Schedule - Jonsered FR 2213 MA Manual De Usuario

5. Select cutting height (1–7) with the cutting height
lever.
6. Press the lock button on the lift lever for the cutting
deck and lower it to mow position.

To stop the engine

1. Pull the lift lever for the cutting deck rearward to its
locked position to lift the cutting deck. The blades
stop to rotate.
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
14
2. Turn the ignition key to the STOP position.
3. When the product stops, apply the parking brake.

To apply and release the parking brake

1. Press the parking brake pedal down (1).
2. Press and hold the lock button (2).
3. Keep the button pressed and release the parking
brake pedal.
4. To release the parking brake, press the parking
brake pedal again.
To get a good result
• Do not cut a wet lawn. Wet grass can give a bad
result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, see
28 ). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
result also at a higher speed.
• To get the best result, cut the grass frequently and
use the mulch function.

Maintenance

X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note: If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
2
1
Technical data on page
826 - 001 -