To Start The Engine; To Operate The Product - Jonsered FR 2213 MA Manual De Usuario

• To lower the cutting deck to mow position, press the
lock button and move the lift lever forward. If the
engine is running, the blades start to rotate
automatically.

To start the engine

1. Make sure that the drive system is engaged, see
engage and disengage the drive system on page 12 .
2. Lift the cutting deck and apply the parking brake.
3. Turn the ignition key to the start position.
4. When the engine starts, immediately release the
ignition key to neutral position.
826 - 001 -
To
2
1
Note: Do not run the starter for more than 5 seconds
at a time. If the engine does not start, wait 15
seconds before you try again.
5. Let the engine run at half throttle (B) for 3-5 minutes
before you apply heavy load.
6. Push the throttle control to full throttle position (C).
A
CAUTION: To engage the blades when the
engine is at full speed causes strain on the
drive belts. Do not apply full throttle until the
cutting deck is lowered to the mow position.

To operate the product

1. Start the engine.
2. Press the parking brake pedal down and then
release it to release the parking brake.
3. Carefully press down one of the speed pedals. The
speed increases the more the pedal is pressed
down. Use pedal (1) to move forward, and pedal (2)
to reverse.
4. Release the pedal to brake.
B C
1
2
13