To Remove The Jumper Cables; Tire Pressure; To Put The Cutting Deck In Mow Position; To Put The Cutting Deck In Servicing Position - Jonsered FR 2213 MA Manual De Usuario

6. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
7. Replace the covers.

To remove the jumper cables

Note: Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.

Tire pressure

The correct tire pressure is 60 kPa (0.6 bar / 8.5 PSI) on
all 4 tires.
To put the cutting deck in servicing
position
WARNING: The drive belt tension spring can
break and cause injury. Wear protective
glasses.
To remove and attach the cutting
1. See step 1–9 in
deck on page 10 .
2. Hold the front edge of the cutting deck with two
hands and pull it out until it stops.
20
3. Lift the cutting deck to vertical position until a click
sound is heard. The cutting deck is locked
automatically in the vertical position.

To put the cutting deck in mow position

1. Hold the front edge of the cutting deck with your left
hand.
2. Loosen the lock with your right hand.
3. Fold down the cutting deck and push it in until it
stops.
4. Lift the cutting height stay from the stay holder and
put it in the hole.
5. Put the drive belt back in its initial position.
6. Attach the tension spring to apply tension to the
drive belt.
7. Attach the front cover.
8. Set the cutting height lever in one of the positions 1–
7.
826 - 001 -