Publicidad
Idiomas disponibles
Idiomas disponibles
Polaris
Robotic Pool Cleaner | Owner's Manual
®
Section 2. Cleaner Specifications
Technical Specifications
The general specifications for the cleaner are as
follows:
Control Box Supply Voltage
Supply Voltage
Installed Load
The cleaner is a double-insulated product.
A double-insulated electrical appliance is one which
has been designed in such a way that it does not
require a safety connection to ground. The basic
requirement for double-insulation is that no single
failure can result in dangerous voltage becoming
exposed so that it might cause an electric shock and
that this is achieved without relying on an earthed
(grounded) metal casing. This is achieved by having
two (2) layers of insulating material surrounding live
parts or by using reinforced insulation. Therefore,
devices having double-insulated construction,
such as this cleaner, do not utilize a grounded
(three-prong) cord/plug.
100-125 VAC, 60 Hz
30 V DC
150 W max
Section 3. Getting Started
3.1
Contents
The packaging should contain the following items:
• Robotic cleaner and floating cable
• Control box
3.2
Connect to a Power Source
WARNING
Failure to comply with the following warnings can result in permanent
injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK
U.S.: Per NEC
requirements, keep the control box at least 5 ft. (1.5 m)
®
from the edge of the pool.
CANADA: Per CEC requirements, keep the control box at least 3 m
(10 ft) from the edge of the pool.
Only connect the control box to a receptacle protected by a ground
fault circuit interrupter (GFCI). Contact a certified electrician if you
cannot verify that the receptacle is protected by a GFCI.
Do not use an extension cord to connect the control box.
Do not allow anyone to swim while the cleaner is in the pool.
The control box is water-resistant, not waterproof. In order to prevent
electrocution, never submerge the control box or leave exposed to
inclement weather.
ENGLISH
Page 5
Publicidad
