Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
4.3
Start / Stop Cleaning and Select
Cleaning Mode
The factory default cleaning mode is set to Floor,
Wall, Waterline.
Use
to change cleaning surface setting.*
Toggle between modes:
Floor Only (1 hour 30 min)
Floor, Wall, Waterline (2 hours 30 min)
With the cleaner submerged in the water,
press
to begin operation.
Press again to interrupt and cancel an in-progress
cleaning cycle.
*not available on all models
4.4
Removal from Pool
Depending on the model, you can manually
remove the cleaner from the pool or use the Lift
System feature.
For manual removal, pull gently on the floating cable
to bring the cleaner handle within arm's reach.
Use the handle to lift the cleaner from the water and
hold the cleaner vertically over the pool surface to
drain (Figure 6). Never lift the cleaner out of the pool
by the floating cable.
Page 8
Polaris
4.5
Using the Lift System
The Lift System is designed to assist in retrieving the
robot from the pool. Lift System can be activated at
any time during or after a cleaning cycle.
1.
Press any button to engage cleaner controls.
2.
Press
on the control box to begin the
automated procedure to bring the cleaner to
the wall.
NOTE: To stop the procedure at any time, press and
release the button again.
3.
Next, press and HOLD
cleaner.
4.
Once the cleaner is facing the wall of your
choice for retrieval, release the button.
5.
Cleaner will drive forward and up the wall
it is facing. It will wait at the waterline to be
retrieved.
6.
When in reach, remove the cleaner from the pool
using the handle. The cleaner will quickly expel
water to allow for lighter, easier removal.
NOTE: Never lift the cleaner out of the pool by the
floating cable.
Figure 6.
Always Remove Cleaner Using the Handle
Robotic Pool Cleaner | Owner's Manual
®
to rotate the
Publicidad
