Publicidad
Idiomas disponibles
Idiomas disponibles
Polaris
Robotic Pool Cleaner | Owner's Manual
®
6.3
Add to Mobile App System
1.
On the My Systems page, click + in the upper
right-hand corner to add a system.
2.
Choose "Robotic Cleaner". Follow in app
instructions to add your cleaner and connect it
to your home router.
3.
On the control box, press
Bluetooth
®
BLINKING - searching for signal
SOLID - paired with phone
Wi-Fi light indicator status:
BLINKING - connected to router
SOLID - connected to the internet
NOTE: Errors during connection may be the results of
insufficient Wi-Fi signal strength at the control box
location. If you are unable to move the control or
router to improve signal strength, you may need a
Wi-Fi extender to boost your signal strength. (See
iAquaLink Troubleshooting section.)
NOTE: An incorrect password may also be that cause
of a connection error. If the signal strength at the
control box is good, double check the network
name and credentials for the router you are trying
to access.
.
light indicator status:
Section 7. iAquaLink
(connected models only)
Once you have downloaded the iAquaLink app and
connected the device to Wi-Fi, the iAquaLink app
allows for robotic cleaner control from anywhere,
anytime. Functions vary within the iAquaLink app
depending on which cleaner model you have.
WARNING
Do not enter pool while the robotic cleaner is in water.
7.1
iAquaLink Control Home Screen
App function and design is subject to change.
Start/Stop Cleaning
Remote*
Clean Mode
Lift System*
*not available on all models
7.2
Start / Stop Cleaning
The factory default cleaning surface setting is Floor,
Wall, Waterline.
1.
From the Home screen or the Control Box press
the Start/Stop button
2.
The app displays the cycle time in hours and
minutes.
3.
Press
to interrupt and cancel an
in-progress cleaning cycle.
ENGLISH
Control
®
to begin cleaning.
Page 13
Publicidad
