Publicidad
Idiomas disponibles
Idiomas disponibles
GRILL SET-UP
UNBOXING YOUR GRILL
1 Cut the plastic bands and remove the top and side panels of the shipping
container.
2 Set the grill cart box aside.
3 Open the dome of the grill and remove the components from the inside of the
grill. Handle the internal ceramic parts with care.
KAMADO JOE GRILL WITH CART
1 Assemble the grill cart.
2 Once the internal components of the grill have been removed, lift the grill
out of the container and into the cart. Due to the weight of this grill, we highly
recommend two people perform this task. Lift the grill by the rear and side
handles only. Do NOT lift the grill by the side shelf tabs, hinge, or front handle.
Wear protective gloves when lifting and use extreme caution.
3 Adjust the grill in the cart so the lower grill vent is facing the front of the cart.
The front side of the cart is the side with the two locking casters.
KONNECTED JOE BUILT IN
Please use this as a general guide for installing your ceramic grill in a built-in
outdoor kitchen or grill table. We highly recommend that the actual grill being
installed be measured.
Table should be fixed on the ground or wall.
Non-flammable building materials are suggested for construction.
Drawing is not to scale.
SIDE VIEW
A
B
C
E
D
F
G
H
To install your Konnected Joe into a built-in kitchen, cart, table, or stand, ensure
the surface the grill sits on has an opening 12.25in(32cm) in diameter directly
underneath the grill to allow cool air to reach the bottom of the grill. Ensure the
surface is non-combustible and can handle high temperatures. Ensure there is rear
access to the grill so you can access the power switch. Use extreme caution, sparks
and hot ash can reach the bottom of this grill.
A B C D E
30.3
26.9
22.3
30.7
OPEN CLEARANCE
I
F G H
14.3
16.4
8.4
18.1
TOP VIEW
M
I
J K L M N O P Q R S
1.6
30.3
26.9
22.3
14
N
J
K
L
T
P
Q
7.8
13.3
22.8
5.5
S
O
R
T
3.6
9.3
13.3
3
Publicidad
