Kamado Joe KJ15041123 Guia página 19

SAFETY INFORMATION DISENGAGEMENT TOOL
HINGE
Do not attempt to disassemble the hinge or loosen the bands from your grill
without the disengagement tool kit.
DISENGAGEMENT TOOL
To install the disengagement tool kit, first place the spacer,
then washer, then hex nut on the spring retainer on the
bottom side of the hinge. Installing the disengagement tool
will release the tension on the spring allowing you to remove
the hinge or bands safely from the grill
LATCH ADJUSTMENTS
The latch on your Konnected Joe is already preset for an ultra-tight seal.
Use these instructions if any adjustments should be needed.
KONNECTED JOE LATCH
To tighten and loosen the latch setting, use a small Allen wrench. Adjust the set
screw to lower the latch plate and add a spacer. Once a spacer is added, reinstall
the latch plate by tightening the set screw.
SPRING
RETAINER
19
WASHER
SPACER HEX NUT