KONTROL BOARD™
Power – Press button to power controller on. Press and hold to power controller off.
AFS (automatic fire starter) – Press button to engage the element to ignite the charcoal. The
element is ON when the red light is glowing. The element will stay on for 15mintues. Press
and hold the AFS button again to turn the element OFF if desired.
Screen Cycle – Press button to cycle through different controller views.
Set Temperature – Press button. Turn knob to desired temperature. Press button again to set
the temperature.
Set Time:
Countdown Timer
1. Press button.
2. Turn knob to desired hours.
3. Press button to set hours.
4. Turn knob to desired minutes.
5. Press button to set minutes.
The timer will start.
6. Press button to pause and resume timer.
7. Press and hold button to reset timer.
Screen Saver Mode:
Press and hold the screen cycle button to activate screen saver mode. In screen saver mode all
set temperatures and timers remain active. The screen will turn black and the Kamado Joe logo
will pulse dimly on the screen. To exit screen saver mode, press any button. Screen saver mode
will also be deactivated if: a meat probe has reached the set temperature, a previously set timer
has been reached, open lid status is activated, or an error message is triggered.
Accessory Mode:
The first time the lid is opened after the controller is powered on, the accessory screen will appear.
If you wish to use one of the listed accessories, press the button on the controller that corresponds
to the accessory, if you do not wish to use an accessory, close the lid. Your selected accessory
should appear in the top right hand corner of your screen on all modes except the graph mode.
Resume normal use of your controller to set your temperatures, timers and meat probes.
Full Griddle:
Please note, the full griddle accessory mode is for use with a griddle that fills the entire cooking
surface. Operate the grill under normal conditions for a half moon griddle surface. When using a
griddle, it is best to shut the lid so the grill can regulate the temperature.
Count Up Timer
1. Press and hold button.
2. Timer will begin counting up
from 00:00. Timer will count
by Minutes:Seconds and then
Hours:Minutes.
3. Press button to pause and resume
timer.
4. Press and hold button to reset timer.
16
3 MEAT PROBES