Cooke & Lewis 5059340127453 Manual Del Usuario página 24

Use
LED Display
• Displays the extraction mode during Set Up or the motor speed from 1-3.
Speed Increase
• Press this icon once to turn on the fan motor at full power, and 3 will display.
• If the motor is already on speed 1-2, each press of this icon will increase the fan speed accordingly.
• If you press and hold the icon for two seconds, the fan speed will increase to full power and 3 will display.
Timer
• When the fan motor is on and the Timer icon is pressed, it will be red and the current speed in the display
will start to flash.
• The chosen speed level will remain in use for five minutes before dropping down to the next lowest
speed. This speed will remain in operation for two minutes before dropping down again. This will be
repeated every two minutes unless the speed is already at level 1 and then the fan will turn off. If the light
is already on, this will also be turned off.
• Pressing the Speed Reduction icon
restart the countdown process again with a five minute cycle.
• If the Timer icon is pressed again during a current timer program, the cycle will be cancelled, the icon
will revert to white and the current fan speed will remain on indefinitely.
• The maximum timer program cycle is 9 minutes: 5 minutes on 3 and then 2 minutes each on speed
2 down to speed 1.
Controlling the cooker hood remotely
IMPORTANT: This section is only applicable if you have also purchased a
compatible induction hob with Radio Frequency (RF) capability. Contact the
Customer Helpline at the end of this manual for compatible models.
Before First Use
This cooker hood model and a compatible induction hob model must be paired by Radio Frequency (RF)
before remote control can occur. This only needs to be done once. When connected the power output of
the induction hob will control the extraction rate of the cooker hood.
To Set Up Connectivity
1. Make sure that the hob and the hood are switched off.
2. Turn on the hob and make sure the connectivity indicator is lit red.
NOTE: Touch the connectivity key
3. Turn on the hood, press and hold both Speed icons
4. Press and hold the Timer icon
will flash in the display.
5. Press the keys and
connection.
6. The control panel of the hood will show "A" for five seconds to indicate connectivity has been made
with the hob.
7. Press the keys and
208872_s1_s1_5059340127453_C&L_A5_IM_Easy-V02.indd 23 208872_s1_s1_5059340127453_C&L_A5_IM_Easy-V02.indd 23
or Speed Increase icon
on the hob if it is not lit.
and Light icon
together on the hob and the connectivity indicator will flash to confirm
together on the hob one more time to store the connectivity settings.
during a current timer program will
together for 3 seconds to enter Set Up mode.
together for 3 seconds on the control panel and "A"
23
20-01-2021 10:31:18 20-01-2021 10:31:18