Publicidad
Idiomas disponibles
Idiomas disponibles
Valve Spring Compressor Set | 16 - 30 mm
TOOLS
1 Tensioning frame
2 Pressure spindle long
3 Pressure spindle for sliding handle 11
4 Pressure piece Ø 30 mm
5 Pressure piece Ø 25 mm
6 Pressure piece Ø 23 mm
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This valve spring compressor is used to compress springs of inlet and outlet valves.
The diameter of the pressure piece is determined by the upper spring carrier.
Because of the provided pressure pieces in 16, 19, 23, 25 and 30 mm, this valve spring compressor
can be universally used on car, motorbike and other four stroke engines.
SAFETY INFORMATIONS
• Keep children and other persons away from the working area.
• Do not allow children to play with this tool or its packaging.
• Do not use the tool if parts are missing or damaged.
• Use the tool for the intended purpose only.
• Never place the tool on the vehicle battery. There is a risk of a short circuit.
• Be careful when working on running engines. Loose clothing, tools and other objects can be
caught by rotating parts and cause serious injury.
• Be careful when working on hot engines because of the risk of burn injuries!
• If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage and personal injuries.
• This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
7 Pressure piece Ø 19 mm
8 Pressure piece Ø 16 mm
9 Tweezers
10 Magnetic telescope
11 Sliding handle for spindle 3
12 Pressure spindle short
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 1768
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
