Publicidad
Q
x 4
FIG. 6
6. Attach End Apron (E) to Left Front Leg (A) and Left Back Leg (B) by gluing Wood Dowels (P).
Make sure the Rafix Cams face into the unit and are on the top edge of the apron. Secure the
pieces together using Screw (Q) through apron pocket holes into each leg.
Repeat the step for the Right Back Leg (C) and the Right Front Leg (D).
T
x 2
Drill out these
pilot holes.
FIG. 7A
7. The Towel Bar (S) can be mounted to either the left or right side of the cart. Once you have
determined which side to mount it on, drill out the pilot holes for that side only. The pilot holes
include a larger countersink hole and smaller hole for the bolt that holds the Towel Bar (S) to the
End Apron (E). Place a 3/16" drill bit into the smaller hole and slowly drill out the hole, making
sure not to tear out the wood on the outside face of the apron. See FIGURE 7A.
Attach the Towel Bar (S) to the End Apron (E) using two Machine Screws (T). See FIGURE 7B.
P
E
P
Q
Q
Right Side Assembly Shown.
E
P
P
Q
Q
B
A
D
C
S
E
T
FIG. 7B
158W — Page 5
T
Publicidad
