Publicidad
Y
x 8
Y
Y
FIG. 13A
13. Attach the Drawer End (I) to the two Drawer Sides (J) using Screws (Y). Make sure the grooves
for the drawer bottom match. Slide the Drawer Bottom (K) into the grooves. Attach Drawer Front
(L) to Drawer Sides (J). Make sure Drawer Bottom (K) fits into the Drawer Front's groove and the
Drawer Sides (J) fit snugly in the two notches in the Drawer Front (L). Secure pieces together
with Screw (Y). See FIGURE 13A.
Square the drawers by measuring from left front to right rear and from right front to left rear. The
measurements should be equal. If one is longer, hold the drawer by the corners on the longest
line and squeeze them together until square. See FIGURE 13B.
V
x 4
FIG. 14
14. Attach Drawer Slides (Drawer Slide Left) (U4) and (Drawer Side Right) (U3) to the drawer. The
wheels should be to the rear and the front edge should be flush against the Drawer Front (L).
Attach the slides with Screws (V). See FIGURE 14.
T
x 2
FIG. 15
15. Attach Towel Bar (S) to Drawer Front
using two Machine Screws (T).
16. To install the drawer, tilt down slightly and place the wheels in the cabinet side slides. Raise to
level and push in. See FIGURE 16.
Page 8 — 158W
I
K
J
V
V
U3
T
T
Y
J
Y
L
S
FIG. 13B
V
V
U4
FIG. 16
Publicidad
