Publicidad
Align first hole
behind wheel with
pre-drilled hole
V
x 6
U2
V
V
O
Left Side
Assembly
Shown.
8. Align the Drawer Slide (Cabinet Side Left) (U2) to the Left Side Assembly by placing the end
with the slide wheel towards the front of the unit and away from the Wood Dowel (P). See
FIGURE 8A. Align the first hole behind the slide wheel over the small pre-drilled hole in the End
Apron (E). Secure the slide to the apron using Screw (V) through this hole. Next, at the end
opposite of the slide wheel, align the bottom edge of the Slide (U2) with the bottom edge of the
End Apron (E). Hold the slide in place and secure the slide to the apron with two more Screws
(V) through two of the remaining smaller diameter holes in the slide. See FIGURE 8A.
Repeat step using Drawer Slide (Cabinet Side Right) (U1) with Right Side Assembly.
See FIGURE 8B.
Q
x 5
FIG. 9
9. Attach Back Apron (F) to Left Leg Assembly gluing dowels and securing with Screw (Q). Make
sure the Rafix Cams face into the unit and are on the top edge of the apron. See FIGURE 9.
Attach both Rack Assemblies (G) gluing dowels and securing with Screw (Q) through pocket
holes in the bottom of the rack supports. See FIGURE 9
Page 6 — 158W
The drawer slide will be stamped with an
"L" for left or an "R" for right in the center
of the wheels. Or they will be stamped
on the body of the slide: "CL" for cabinet
left; "DL" for drawer left; "CR" for cabinet
right; "DR" for drawer right.
V
FIG. 8A
Q
P
P
Top
P
Align bottom of slide
with bottom of
side apron at this point
Q
Q
Q
O
O
O
Align first hole
behind wheel with
pre-drilled hole
V
V
FIG. 8B
Q
O
Bottom
U1
V
O
Right Side
Assembly
Shown.
Publicidad
