Publicidad
Using the Configuration Page
Certain set-up and configuration options are available on the password-protected
3M™ Attest™ Auto-reader 390 Web App Configuration page. Ideally, the 3M™ Attest™
Auto-reader 390 should be empty (i.e., have no incubating BIs) when it is reconfigured.
Navigate to the Configuration page by entering either:
1) http://attestxxxxxx/protect/config.htm (where xxxxxx is the 6-digit unit serial number), or
Click on the desired radio buttons to change settings.
Auto-reader Type
Language
Pushbutton
Configuration
Buzzer
Configuration
Attest Auto-reader
390 Nickname
Enable DHCP
IP Address
Gateway
Subnet Mask
Primary DNS
Use Computer
Time
Attest Auto-reader
390 Time
After changing desired settings, click on Save Config button to save your changes. A new screen confirming the settings were successfully changed appears.
Rendered on 5/8/2013 10:56:36 AM
Select the configuration desired for wells 1-5/6-10 by clicking on the appropriate radio button.
Selected setting indicates language in which text on 3M™ Attest™ Auto-reader 390 Web App pages will appear on the PC/mobile device screen.
Selecting Enable
allows the user to configure the 3M™ Attest™ Auto-reader 390 from the buttons on the unit itself.
Selecting Disable
prevents the user from being able to configure the 3M™ Attest™ Auto-reader 390 from the buttons on the unit itself.
Selecting Enable
enables the audible alarm. The speaker icon will appear on the 3M™ Attest™ Auto-reader 390 LCD panel.
Selecting Disable
disables the audible alarm. The speaker icon will disappear from the 3M™ Attest™ Auto-reader 390 LCD panel.
Naming the 3M™ Attest™ Auto-reader 390 may be useful in facilities with multiple units. The assigned nickname will appear on the 3M™ Attest™
Auto-reader 390 Web App Status page.
Default: Setting is checked indicating the Web App will use the Dynamic IP address automatically assigned when the 3M™ Attest™ Auto-reader 390 is
connected to the network. Remove the check if you wish to use a Static IP address assigned by your facility IT.
Enter Static IP address assigned by IT.
Enter Gateway.
Enter Subnet Mask.
Enter Primary DNS.
Check this box if you wish to set the clock on-board the 3M™ Attest™ Auto-reader 390 using the computer's clock.
Alternatively, leave the Use Computer Time box unchecked and complete the date and time boxes to set the 3M™ Attest™ Auto-reader 390 clock.
2) http://xxx.xx.xxx.xx/protect/config.htm (where xxx.xx.xxx.xx is the IP address)
in the web browser address bar and pressing Go or Enter. A security screen will appear. Fill
in the fields as follows:
User name: manager
Password: Attest
and press OK.
Page 13
11
34871202858.pdf
Publicidad
