Publicidad
Idiomas disponibles
Idiomas disponibles
Transportation And Storage
Transportation
Feed all of the cable into the drum. Remove any cutter or
tool from the cable. Make sure that no more than 6" cable
is outside the drum. Tighten the AUTOFEED knob onto
the cable. Wrap the foot switch hose around foot switch
hose wrap. See Figure 27 .
Before moving the machine, make sure that the tele-
scoping handle is secured into the extended position for
transport. If the machine needs to be lifted, use proper
lifting techniques. Use care moving equipment on stairs
and be aware of possible slip hazards.
Manual Loading
With the telescoping handle locked into the extended
position, place machine with wheels toward the vehicle.
Lean the machine back and rest the loading wheels on
the vehicle bed. Use loading handles to lift the machine
and slide it onto the vehicle (Figure 26). Use care not
to damage foot switch hose. Be aware of the machine
weight. Use proper lifting techniques – more than one
person may be required.
Loading with Crane/Winch
If lifting with a crane/winch, entire machine weight can
be carried with handle. Lock the telescoping handle into
lowest position for lifting. Depending on which drum is
being used the angle in which the machine rests may
vary (Figure 27).
Figure 26 – Loading on a Vehicle
999-995-420.10_REV A
K-4310 FXP Drum Machine
Figure 27 – Loading with Crane/Winch
Storage
WARNING
The K-4310 FXP Drum Machine must
be kept dry and indoors or well covered if kept outdoors.
Store the machine in a locked area that is out of reach
of children and people unfamiliar with drain cleaning
machines. This machine can cause serious injury in the
hands of untrained users.
Maintenance Instructions
WARNING
The main ON/OFF switch should be OFF and battery
or adapter removed before performing any main-
tenance. Always wear safety glasses and other
appropriate protective equipment when performing
any maintenance.
Cleaning
After each use, clean the machine. A mild detergent or
antibacterial solution can be used if desired. Do not use
solvents, abrasives or other harsh cleaning agents.
Machine – Use a damp, soft cloth to wipe off the machine.
Do not submerge or flush the machine with water. Do not
allow water to enter motor or other electrical components.
Make sure unit is completely dry before inserting battery
or adapter and using.
Drum and Cable – Flush the drum and cable with water
after every use to prevent damaging effects of sediment
and drain cleaning compounds. Allow to dry to reduce
cable corrosion.
21
Publicidad
