Amprobe SOLAR-500 Manual De Uso página 24

Setup Menu
1. Press
2. Press
(1) Time delay before scan
(2) Current Range of Scan begin
(3) Current Range of Scan end
(4) Area of Solar Cell or Panel
(5) Irradiance
(6) Single Test Point
(7) Alarm of Low Power
3. Press
Press or
few seconds to promptly change setting values.
4. After setting Parameters, press
(SETUP) button to enter the Parameter Setting screen.
or buttons to select the setting items.
or buttons to select the setting items.
buttons to change the setting values, or press them for
button to exit SETUP menu.
17