MTF UB 1200EB Manual Del Usuario página 31

Warning: Other maintenance and repair work than those listed in this manual, must
only be performed by an authorized manufacturer's service. When the cable is
damaged it may only be replaced by an authorized manufacturer's service. Safety and
operational reliability can only be guaranteed when using original spare parts.
The power tool is almost maintenance-free
• Keep the power tool and the air vents clean and unplugged.
• Make sure that no moisture reaches the inside of the power tool during cleaning.
• Service repair consists of replacing worn carbon brushes only (contact your seller or a qualified
electrician).
Cleaning
• Clean the power tool after every use. Remove dust with a brush or compressed air if necessary.
• Clean the power tool with a wet cloth. Do not use cleaning agents or solutions; these can corrode
the plastic parts of the power tool.
Storage
• Keep the tool in a dry and safe place.
TROUBLESHOOTING
Problem
Grinder does not work
Vibrations are too strong
Motor overheated
TECHNICAL DATA
Angle grinder MTF UB 1200EB
Rated voltage
Frequency
Input power
No load speed
Grinding / cutting wheel diameter
Perimeter speed
Spindle thread
Weight without accessories
Protection class
Noise and vibration
The declared vibration level stated in the technical data and in the declaration of conformity has been
measured in accordance with the standard test method prescribed by the relevant standards and can be
used to compare individual tools with each other. The declared vibration level can also be used to
predetermine exposure.
Possible cause
Mains socket is not live
Power cable fault
Screws or parts of the
machine are loose
Grinding / cutting wheel is
loose or not clamped
properly
Grinding / cutting wheel is
damaged
Overload due to excessive
pressure to grind / cut
EN - 31
Solution
Check mains socket and/or circuit
breaker/RCD
Check whether power cable is
disconnected or damaged
Check and tighten all screws
Check and re-fit the wheel properly
Replace the wheel
Allow the motor to cool down by running
the tool idle for 3 minutes
220-240 V
50 Hz
1200 W
12000 / min
125 mm
72 m/s
M14
2,4 kg
II