GreenWorks MO80L08 Manual Del Operador página 12

EN
Lights Capacity
4 Green The battery is above 80% capacity
Lights
3 Green The battery is between 80% and 60%
Lights capacity
2 Green The battery is at between 60% and
Lights 40% capacity
1 Green The battery is between 40% and 20%
Light capacity
Lights go The battery is less than 20% capacity
out and requires charging immediately
8.2 STOP THE MACHINE
1. Release the start handle to stop the machine.
Wait until the blade fully stops before you start the
machine again. Do not quickly turn the machine off
and on.
Always remove the safety key and battery pack after
you complete the work.
8.3 OPERATE THE SELF-PROPEL DRIVE
SYSTEM*
1. Start the machine.
2. While you hold the start handles, grab either of
the drive levers and pull towards the handle bar.
3. Hold the start handles and the drive levers at the
same time.
4. Release either set of start handle and drive lever
from the same side.
5. Adjust the speed control with your free hand.
• Slide the speed control button in the direction
of the Rabbit Symbol to increase the speed.
WARNING
WARNING
English
• Pull the speed control button in the direction of
the Turtle Symbol to decrease the speed.
6. Release the drive levers to close the self-propel
system.
To engage the self-propel drive system while the
mower is not running:
• Press and hold the start button, then pull up on the
drive lever.
OR
• Pull up on the drive lever, then press the start
button.
Some models are not equipped with self-propel
function.
8.4 LED HEADLIGHT
1. When the mower is ready to start, you may grab
the start handle or the self-propel lever to turn on
the LED headlight.
2. Release the start handles and self-propel levers
to turn off the headlight.
8.5 EMPTY THE GRASS CATCHER
1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook
it from the slots.
6. Close the rear discharge door.
7. Empty the grass catcher.
8.6 OPERATION TIPS
• Do not try to override the operation of the start
button or start handles.
• Do not tilt the machine when you start it.
12
NOTE