EN
1.
Remove the grass catcher.
2.
Remove the battery and safety key.
3.
Pull through the handle holes to fold away the
handles.
4.
Lock the handles into position.
5.
Stand the machine on end and make sure that
the brackets touch the floor.
9.3
STORE THE MACHINE
• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person at an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
10
TROUBLESHOOTING
Problem
The handle is
not in position.
The machine
does not start.
The machine
cuts grass un-
evenly.
The machine
does not mulch
correctly.
Possible cause Solution
The bolts are
Adjust the
not engaged
height of the
correctly.
handle and
make sure that
the bolts and
nuts are aligned
correctly.
The battery ca-
Charge the bat-
pacity is low.
tery pack.
The start han-
Replace the
dle is defective.
start handle.
The battery key
Put in the bat-
is not put in.
tery key.
The lawn is
Examine the
rough.
mowing area.
The blade
Move the
height is not set
wheels to a
correctly.
higher position.
Wet grass clip-
Wait until the
pings attach to
grass dries be-
the deck.
fore mowing.
The mulch plug
Install the mulch
is missing.
plug.
English
Problem
The machine is
hard to push.
There is a high
vibration in the
machine.
The machine
stops during
mowing.
* If you cannot find the solution to these problems, go
to the service center.
14
Possible cause Solution
The grass is too
Increase the
tall, or the blade
blade height.
height is too
low.
The grass
Empty the grass
catcher and the
clippings from
blade drags in
the grass catch-
thick grass.
er.
The blade is un-
Replace the
balanced and
blade.
worn.
The motor shaft
1.
Stop the
is bent.
motor.
2.
Remove
the safety
key and
battery
pack.
3.
Disconnect
the power
source.
4.
Inspect for
damage.
5.
Repair the
machine
before you
start it
again.
The blade
Increase the
height is too
blade height.
low.
The battery
Charge the bat-
pack is out of
tery pack.
power.
The grass clip-
Remove the
pings attach to
battery pack
the deck or the
and check the
blade.
deck.
Operation tem-
Cool the ma-
perature of the
chine.
machine is too
high.