GreenWorks MO80L08 Manual Del Operador página 13

• Do not put hands or feet near or below the turning
parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick
grass.
• Clean the bottom of the mower deck after each
use. Remove grass clippings, leaves, dirt, and other
debris.
9 MAINTENANCE
WARNING
Remove the safety key and battery pack from the
machine before maintenance.
WARNING
Keep the motor and battery pack free from grass,
leaves or too much grease.
CAUTION
Use only approved replacement parts.
CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the
plastic housing or components.
9.1 REPLACE THE BLADE
16
A
15
14
19 18
18
A
16
English
17
B
19
B
17
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade
when you touch the blade.
1. Stop the machine.
2. Make sure that the blades fully stop.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of
the blade.
6. Remove blades with a wrench or a socket:
• Turn nut (18) to the right to remove blade A (14),
spacer (19) and positioner (16);
• Turn nut (18) to the left to remove blade B (15),
spacer (19) and positioner (17).
7. Install the new blade. Position the blade with the
cutting edges toward the ground. Make sure the
two posts on positioner engage the holes on the
blades.
8. Assemble the positioners and spacers as shown.
Positioner (16) for blade A only; positioner (17) for
blade B only. Mounting nuts and spacers of blade
A are interchangable with that of blade B.
9.2 VERTICAL STORAGE
1
3
13
WARNING
WARNING
2
EN