Publicidad
Idiomas disponibles
Idiomas disponibles
VACUUM BLENDING WITH THE
SINGLE-SERVE FRESHVAC™ CUP – CONT�
IMPORTANT: Review all warnings on
pages 4–7 before proceeding.
13 When blending is complete, rotate
cup counterclockwise to remove from
motor base and place cup on a level
surface. Pressure must be released
before opening the cup. The FreshVac™
Cup may be stored in the refrigerator
with the spout lid for later use. DO NOT
store contents in the cup with the Pro
Exactor Blades® Assembly attached.
14 Open the Flip & Seal Lid by pressing the
tab and lifting. To release the vacuum
seal, gently lift the FreshVac Tab. Air
will enter the cup, making it easy to
remove the blade assembly.
DO NOT PULL TAB OUT
22
15 Turn cup over so blade assembly
is on top. Rotate blade assembly
counterclockwise to remove. To take
your blended contents on the go, place
the spout lid on cup and turn clockwise
to seal.
16 Unplug the unit when finished. To lift
the motor base, place your hands
underneath both sides of it and gently
pull the unit up and toward you. Refer
to the Care & Maintenance section for
storing instructions.
TRADITIONAL BLENDING WITH
THE SINGLE-SERVE FRESHVAC™ CUP
1 Add ingredients to the FreshVac Cup.
DO NOT add ingredients past the MAX
LIQUID line on the cup.
2 Place the Pro Extractor Blades® Assembly
on the top of the cup and turn clockwise
to seal.
3
Place the unplugged motor base on
a clean, dry, level surface such as a
countertop or table. Press downward
on the motor base to adhere the
suction cups to the work surface. Plug
the motor base into a wall outlet.
4 Turn the Single-Serve Cup upside down
and install on the motor base. Align the
tabs on the cup with the slots on the base,
then twist until it clicks into place. Touch
the Power symbol to turn unit on. The
available program buttons will illuminate
and the unit will be ready for use.
5
If using a pre-set program, first select the
program that best suits your recipe. The
pre-set feature will automatically stop the
unit at the end of the program. To pause
the unit at any time, touch the currently
active program a second time. Reference
page 10 for program descriptions.
6
When blending is complete, rotate cup
counterclockwise to remove from motor
base and place cup on a level surface.
Pressure must be released before opening
the cup. The FreshVac™ Cup may be stored
in the refrigerator with the spout lid for later
use. DO NOT store contents in the cup with
the Pro Exactor Blades® Assembly attached.
7
Turn cup over so blade assembly is on top.
Rotate blade assembly counterclockwise
to remove. To take your blended contents
on the go, place the spout lid on cup and
turn clockwise to seal.
8
Unplug the unit when finished. To lift the
motor base, place your hands underneath
both sides of it and gently pull the unit
up and toward you. Refer to the Care &
Maintenance section for storing instructions.
ninjakitchen.com
23
Publicidad
