Publicidad
Idiomas disponibles
Idiomas disponibles
d. Control Mode - Indicator light corresponding to "CM" shines green.
In control mode, the tool runs at low-speed at first to help engage the screw into work piece.
Once the screw is well engaged, the tool will increase speed automatically to finish the work
efficiently with steady control over the process. The control mode is available only when the
tool is set in forward rotation (to drive screws in). If the tool is switched to reverse rotation
while in control mode, the impact force and speed are the same as the medium-speed mode "2".
The modes can also be changed when the tool is set in reverse rotation to allow a loosening
force suitable to the work at hand.
NOTICE: The work mode can be changed only when any mode-indicator light is shining and
the trigger switch is not depressed. The mode button is disabled when the motor is running.
The work mode will be stored in memory and reactivated the next time the tool is turned on or
when the direction of rotation has been changed. Reset the modes as desired.
When the trigger is squeezed slightly or the mode button is pressed, any of the four indicator
lights will automatically shine green, to indicate the work mode saved during the last use and
will turn off approximately 60 seconds after the variable speed trigger switch is released. It
means that during approximately one minute after releasing the switch trigger, the work mode
can be changed.
Work mode
displayed
Low-Speed Mode
Medium-Speed Mode 3400
High-Speed Mode
Control Mode
(forward)
Removable Belt Clip (Fig . 7)
Your tool is equipped with a removable belt clip
that can be positioned on the left side of the
tool for convenient transport.
To install the belt clip onto the tool:
a. Remove the battery pack from the tool.
b. Align the rib of the belt clip with the threaded
hole on the base of the tool.
c. Insert the screw and securely tighten the
screw with a Phillips head screwdriver
(not included).
14
Maximum Impact
Rate (IPM)
2450
3950
3950
Purpose
Applying less torque
to avoid screw thread
breakage.
Applying medium
torque and speed.
Applying high torque
and speed.
Steady control of
driving screws.
Fig . 7
Example of
application
Driving small screws in
light-duty applications;
assembling furniture.
Driving screws
in medium duty
application.
Driving heavy-
duty wood screws,
tightening small bolts.
Driving long screws.
Publicidad
