Publicidad
Idiomas disponibles
Idiomas disponibles
Planting operations
1) To prevent overloads on the ploughshare, the tractor
driver must lower the work vehicle with the tractor
moving forwards at low speed. Do not reverse the
tractor with the work vehicle on the ground as this
could damage the ploughshare.
2) Load the seedlings into the dispenser and keep it
loaded during the planting stage.
Do not load the seedlings into the front cups as they
are continually opening and closing.
3) The operators on the work vehicle must decide on
Seat positioning
Poor work posture will tire the operator and could lead
to mistakes being made; therefore, before starting work,
adjust the seat and secure it in the position that offers
maximum comfort.
A) Lever: this is used to adjust the seat lengthways.
Release the lever and then move the seat forwards or
backwards.
Secure the seat in the right position using the lever.
B) Lever: this is used to adjust the seat tilt.
Release the lever and then tilt the seat forwards or
backwards.
Secure the seat in the right position using the lever.
Tray changeover
Swap the empty trays for full ones as outlined below.
1) Push the empty tray (A), upwards and turn it so it
comes off the lower runner; now lift it out of the tray
holder runners completely.
2) Place the full tray so that it is touching the upper run-
ner (B), turn it round and then lower it onto the lower
runner (C).
Night-time work or poor visibility conditions
Working at night or in poor visibility conditions increases
the risks arising from machine use; in these conditions,
English language
INFORMATION FOR USE
the tractor's speed of travel together with the tractor
driver so that a least 60 seedlings can be placed in
the dispenser per minute and correct ejector/seed-
ling timing is obtained.
4) Move forwards with the tractor before starting the
planting.
5) The operators on the work vehicle must check the
planting quality constantly. In the event of anoma-
lies, stop the tractor moving forwards and adopt cor-
rective measures (see "Information on adjustments"
and "Troubleshooting"- pages 12 and 33).
UN41 0069CF
C) Screws: these are used to adjust the seat height.
Unscrew the screws and then raiser or lower the
seat.
Tighten the screws to secure the seat in the right po-
sition.
B
C
UN41 0068CF
proper lighting must be provided to ensure safe work.
27
6
B
C
A
Use and maintenance
Publicidad
