Parkside PDOS 200 B2 Traduccion Del Manual De Instrucciones Originale página 26

GB IE
• Switch the device off and remove the
mains plug
- to loosen a blocked insertion tool,
- if the connection line is damaged or
entangled,
- in case of unusual sounds.
Residual risks
Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage, if suitable respiratory
protection is not worn.
b) Hearing damage, if suitable ear pro-
tection is not worn.
c) Damages to health due to
- touching the area of the grinding tool
which was not covered;
- the ejection of pieces from workpiece
or damaged grinding discs.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and the
manufacturer of their medical im-
plant before operating the machine.
26
All manuals and user guides at all-guides.com
Assembly
Caution! Risk of injury!
- Ensure that you have sufficient
space in which to work, and that
you do not endanger other peo-
ple.
- Always fasten the device on to the
work surface with screws featuring
the sufficient length and thickness
in order to maintain control of the
device.
- All covers and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug before
changing the setting on the device.
Figure and Figure
to fit the spark protection and work-
piece support on the left-hand side
of the device. Fit the second spark
protection and the second work-
piece support
Assemble/adjust spark
protection
You will need a screwdriver and
a spanner (size 8 mm) to use as a
counter holder to fit the above.
1. Screw the spark protection (1) to
the spark protection holder (2). To
do this, use the fixing screws (4),
nut (4a), spring washer (4b) and
washer (4c) supplied.
2. Fit the second spark protection in
a similar manner.
3. Screw the spark protection holder
(1) firmly to the protective hood
(5). To do this, use 1 adjusting
screw including the spring washer
show how