Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Overview and function
Material damage and failure of the joint due to exeeding the
maximum joint angle!
► Do not bend the joint past the maximum permissible angle, neither whilst in operation
or at a standstill.
Exceeding the joint angle specified in Chapter 2.3.1 on page 33 results in premature wear and damage
to the PTO drive shaft. If a larger joint angle is required, it is necessary to consult Walterscheid.
PTO drive shaft arrangement
Z
W
1
2
2
2
During operation, strive for small and equal joint
angles. In the case of large and uneven joint
angles, switch off the PTO.
A combination of Z and W bends is not
permissible.
For PTO drive shafts with a wide angle joint:
The pivot between the tractor and the device
should be the same as the pivot of the wide angle
joint (1).
The single joint should run stretched (2).
32
Publicidad
