Roborock Q5+ Manual Del Usuario página 10

Note: If the robot fails to find the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
Error
If an error occurs, the power indicator will
flash red and a voice alert will sound. See "
Errors" for solutions.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually will
end the current cleanup.
System Reset
If the robot does not respond when a button
is pressed or cannot be turned off, reset
the system. Press the Reset button, and the
robot will reset automatically.
Note: After resetting the system, scheduled cleaning, WiFi,
etc. will be restored to factory settings.
Restore Factory Settings
If the robot does not function properly after
a system reset, switch it on. Press and hold
the button and at the same time press
Reset button until you hear the "Restoring
factory settings" voice prompt. The robot
will then be restored to factory settings.
App Features
Cleaning Map
• Multi-Map Management
• Real-Time Vacuum Route
• Map Zoning
• Map Editing
Custom Cleaning Modes
• Scheduled
• Selective Room
• Zone
• No-Go Zones & Invisible Wall
Cleaning Mode Switch
• Suction Power Levels
• Custom
Robot Information
• Cleaning History
• Battery Level
• Care & Maintenance
More Features
• Firmware Update
• Volume Adjustment
• Language Selection
• Do Not Disturb Mode
• Voice Assistant Support
Note: Functions and details of the app may vary slightly due
to the continuous app development and updates.
Routine Maintenance
C
Main Brush
C1
* Clean every 2 weeks and replace every 6-12 months.
C1-1—Main Brush Cover
C1-2—Latches
C1-3—Main Brush
10
C1-4—Main Brush Bearing
C1-5—Turn over the robot and press the
latches to remove the main brush cover.
Pull out the main brush and remove the
main brush bearing.
C1-6—Use the main brush cleaning tool to
remove any hair entangled around the
main brush.
Notes:
• If there is a large amount of hair, or hair is tightly entangled,
remove it carefully to avoid damage to the main brush.
• Use the main brush cleaning tool carefully to avoid injury.
Keep out of reach of children.
C1-7—After removing the tangled hair or dirt
at the main brush, reinstall it, press on the
main brush cover to lock it in place.
Notes:
• Main brush should be wiped down with wet cloth and left to
dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to clean
the main brush.
Side Brush
C2
* Clean monthly and replace every 3-6 months.
1. Unscrew the side brush screw.
2. Remove and clean the side brush. Reinstall
the brush and tighten the screw.
Omni-Directional Wheel
C3
* Clean as required.
C3-1—Use a tool, such as a small screwdriver,
to pry out the axle and take out the wheel.
Note: The omni-directional wheel bracket cannot be removed.