Braun MultiQuick 9 HB901AI Manual De Instrucciones página 16

English
Before use
Please read the user instructions carefully
and completely before using the appliance
and retain for future reference. Remove
all packaging and labels and dispose them
appropriately.
Parts and Accessories
1 imode selector
a high speed
b low speed
c pulse
2 Safety button
3 Smartspeed switch / variable speeds
4 Motor part
5 EasyClick Plus release buttons
6 ActiveBlade shaft
7 Beaker with Lid
8 Whisk accessory
a Gearbox
b Whisk
9 Puree accessory
a Gearbox
b Puree shaft
c Paddle
10 500 ml chopper accessory «mc»
a Lid (with gear)
b Chopping blade
c Ice blade
d Chopper bowl
e Anti-slip rubber ring
11 2000 ml food processor accessory XL
with Dicer «fpl»
a Lid (with Gearbox)
b Coupling for motor part
c Pusher
d Feed tube
e Lid latch
f Splash Guard
g Food processor bowl
h Anti-slip rubber ring
i Chopping blade
j Chopping blade cover
k Dough Tool (FP)
l Kneading hook (Dicer)
m Dicer Blade
n Dicer Base
o Cleaning pusher
p Insert holder
(i) Slicing insert (fine, coarse)
(ii) Shredding inserts (fine, coarse)
(iii) Julienne insert
q French fries disc
r Disc axle
12 Stand for storing
16
How to Use the Appliance
Smartspeed Switch for
Variable Speeds
One squeeze, all speeds. The more you press, the
higher the speed. The higher the speed, the faster
and finer the blending and chopping results.
One handed operation: the Smartspeed switch (3)
allows you to turn on the appliance and control the
speed with one hand.
Switching On (A)
The appliance comes with an imode selector (1) and
a safety button (2) for releasing the Smartspeed
switch (3). Please follow the instruction to start the
appliance:
• By pressing the silver part of the top you can
choose one of the 3 different imodes (high
speed, low speed, pulse).
• After choosing the mode, press the safety button
(2) with your thumb.
• Immediately press the Smartspeed switch and
adjust to the desired speed.
NOTE: If the Smartspeed switch is not pressed
within 2 seconds, the appliance cannot be
switched on for safety reasons. The safety button
light will flash red. To switch the appliance on,
start again.
• During operation you do not need to keep the
safety button pressed.
Pilot light
Safety button
light Flashing red
Safety button
light off
Standby mode
after 10 minutes.
All lights switch
off.
Safety button light
solid red and
imode selector
lights are all
flashing
ActiveBlade Shaft (B)
The hand blender is equipped with an ActiveBlade
shaft, which enables the knife extend to the bottom
Appliance / Operating status
Appliance is ready for use.
Appliance is released (switch
release button is pressed) and
can be switched on.
Device is active again if any
button is pressed
Device is overheated. Let the
device cool down one hour. It
is ready for use again when
the imode selector light stops
flashing and the safety button
light flashes.