Installation Instructions; Flow Diagram - Hansgrohe Axor Citterio M 34820000 Modo De Empleo/Instrucciones De Montaje

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages.After it has been installed, no transport or
surface damage will be honoured.
• As a standard, the mixer is supplied with a C aerator.
If the water jet tends to splash when hitting the sink,
exchange the C aerator for the aerator (comprised in
the delivery) which has a lower flow rate.
• The fitting must be installed, flushed and tested after
the valid norms.
Technical Data
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
The product is exclusively designed for drinking water!
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
4
English
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
max. 70°C / 4 min
Assembly see page 31
Symbol description
Do not use silicone containing acetic acid!
Adjustment (see page 35)
To adjust the hot water limiter on single lever
mixers, please see page 35. Using a hot
water limiter in connection with a continuous
flow water heater is not recommended.
Cleaning
see enclosed brochure.
Dimensions (see page 36)

Flow diagram

(see page 36)
Operation (see page 37)
Hansgrohe recommends not to use as
drinking water the first half liter of water
drawn in the morning or after a prolonged
period of non-use.
Spare parts (see page 38)
XXX = Colors
000 chrome plated
800 stainless steel optic
Test certificate (see page 40)