RS Pro RS-988 Manual De Instrucciones página 16

Operating Instruction for Thermal Imager / English
6-10-1.Analyse an Image
When current file type is image, press " " to enter image analysis mode.
Which can change the measure parameters, analyse tools, image mode and color on the image.
6-10-2.Play a Video
When current file type is video, press " " to play video.
Play Video
6-10-3.View Image Info
Press " " to delete the current file.
6-10-4.Delete a File
Press " " to delete the current file.
28
6-11.USB Mode
• Connect USB cable to device, popup the menu as follow:
• There are two modes for USB, Storage and PC Camera. press up or down button to switch mode.
7.Fault Diagnosis and Exclusion
• If you encounter any problems while using the thermal imager, overhaul according to the following table.
• If the problem persists, disconnect the power and contact with the company's technical support
Phenomenon of the fault
Thermal imager cannot start
Thermal imager shut down
No Thermal image
Stop Play Video
Operating Instruction for Thermal Imager / English
department.
Cause of the fault
No battery
No power
No power
The lens cap cover
Solution
Inserting the battery
Replace the battery or charge it
Replace the battery or charge it
Opened the lens cap
29