RS Pro RS-988 Manual De Instrucciones página 2

Operating Instruction for Thermal Imager / English
1. Introduction
• The Thermal imager is handheld imaging camera used for predictive maintenance, equipment
troubleshooting and verification.
• Focus the lens to the object, then the thermal and visual images are displayed on the LCD and can be
saved to a Micro SD Memory card.
• Transferring images to a PC is accomplished by removing the SD memory card and connecting it to a
PC through the included card reader, or transfer the images and video stream to the smart device with
"Thermoview Pro" apps installed.
• In addition to the features mentioned above, the Thermal imager provide video recording and play back.
2.Safety Information
• To prevent eye damage and personal injury, do not look into the laser. Do not point laser directly at
persons or animals or indirectly off reflective surfaces.
• Do not disassemble or do a modification to the Thermal imager.
• Do not point the Thermal imager (with or without the lens cover) at intensive energy sources, for
example devices that emit laser radiation, or the sun.
• This can have an unwanted effect on the accuracy of the camera. It can also cause damage to the
detector in the Thermal imager.
• Do not use the Thermal imager in a temperature higher than 50°C (122°F), lower than-20°C (-4°F). High
temperature or low temperature can cause damage to the Thermal imager.
• Only use the correct equipment to charge the battery.
• If you do not use the correct equipment, you can decrease the performance or the life cycle of the
battery, If you do not use the correct equipment, an incorrect flow of current to the battery can occur,
This can cause the battery to become hot, or cause an explosion and injury to persons.
• Do not pull out the battery when the thermal imager is working.
• If you pull out the battery when the thermal imager is working, it may cause the thermal imager work
unnormal.
• Do not disassemble or do a modification to the battery.
• The battery contains safety and protection devices which, if they become damaged, can cause the
battery to become hot, or cause an explosion or an ignition.
• If there is a leak from the battery and the fluid gets into your eyes, do not rub your eyes, Flush well with
water and immediately get medical care.
• Do not make holes in the battery with objects, Do not hit the battery with a hammer, Do not step on the
battery,or apply strong impacts or shocks to it.
• Do not put the battery in or near a fire, or in direct sunlight, or other high-temperature locations, Do not
solder directly onto the battery.
• Always charge the battery in the special temperature rang.
1