Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Problem
The grill cannot be lit
The burner flame goes out.
Low heat even though the
dial is set to HIGH.
Low heat (caused by the
gas pipe system)
Potential cause
The clearance between the
ignition pin and the burner
is greater than 5/32 to
3/16 inches.
The electrode tip does
not produce sparks at the
burner orifice.
The gas supply is not
working.
The gas bottle is empty.
The gas supply is not
sufficient.
The gas bottle is empty.
The gas regulator
assembly contains an
overflow device that
provides an adequate
supply of gas to the grill.
Rapid changes in gas
pressure can trigger the
overflow device, resulting
in a low flame and low
temperature.
Potential solution
Loosen the firing pin and
adjust the distance. Then
fasten it again.
Reinsert the electrode.
Turn on the regulator
valve.
Replace the gas bottle.
Check the gas hose and
make sure there are no
leaks or knots.
Replace the gas bottle.
Follow these instructions:
• Make sure all rotary
knobs are in the
"OFF" position.
• Open the gas
cylinder valve and
wait 5 minutes.
• Light the burners one
by one, following the
ignition instructions
listed on the door
panel.
EN
37
Publicidad
