Klarstein KINGSVILLE 4.1 Manual De Instrucciones página 37

TROUBLESHOOTING
Problem
The grill cannot be lit
The burner flame goes
out.
Low heat even though
the dial is set to HIGH.
Low heat (caused by the
gas pipe system)
Potential cause
The clearance between
the ignition pin and the
burner is greater than
5/32 to 3/16 inches.
The electrode tip does
not produce sparks at
the burner orifice.
The gas supply is not
working.
The gas bottle is empty.
The gas supply is not
sufficient.
The gas bottle is empty.
The gas regulator
assembly contains an
overflow device that
provides an adequate
supply of gas to the grill.
Rapid changes in gas
pressure can trigger
the overflow device,
resulting in a low flame
and low temperature.
Potential solution
Loosen the firing pin and
adjust the distance. Then
fasten it again.
Reinsert the electrode.
Turn on the regulator
valve.
Replace the gas bottle.
Check the gas hose and
make sure there are no
leaks or knots.
Replace the gas bottle.
Follow these
instructions:
• Make sure all rotary
knobs are in the
"OFF" position.
• Open the gas
cylinder valve and
wait 5 minutes.
• Light the burners
one by one,
following the
ignition instructions
listed on the door
panel.
EN
37