Publicidad
Idiomas disponibles
Idiomas disponibles
13. CH1 output (+ and - pole)
13a. CH1 channel's ground
14. CH2 output (+ and - pole)
14a. CH2 channel's ground
15. CH3 output (+ and - pole)
15a. CH3 channel's ground
16. Output indicator
17. DC voltage indicator
18. Quick settings recall indicator
19. DC current indicator
20. USB port (only
21. RS232 port (only
22. Power socket
23. Ventilation holes
3.2.
POSITIONING OF THE UNIT
The unit should be placed on a work surface that is at least equal in size to the unit's
size. For optimal operation of the device, the work surface should be flat, dry, heat
resistant and should be placed at the proper height. Ensure that the power supply to
the unit corresponds to that specified on the identification plate!
3.3.
1. Startup and configuration of output parameters
a) Connect the power cord to the power socket (22) on the rear panel of the
unit. Connect the power cord plug to a power source.
b) Switch on the unit by pressing the POWER button (1).
c)
Set the output parameters:
- press CH1 button - default parameters will show on the display,
- to change the voltage value, briefly press the voltage adjustment knob (9),
pressing the knob again changes the position of the cursor on the display,
turn the knob to set the value of the flashing digit,
- to change the amperage value, briefly press the amperage adjustment knob
(8), pressing the knob again changes the position of the cursor on the display,
turn the knob to set the value of the flashing digit.
d) After completing the settings press the output activation ON/OFF button (2).
e) To turn off the device press POWER button (1) again.
2. Serial/parallel operation mode
S-LS-114)
S-LS-114)
Preparation for operation
Working with the unit
Publicidad
