Loewe klang bar3 mr
Important safety instructions
1
Important safety in-
structions
Attention: Read this page carefully to ensure
safe operation of the device.
Follow all safety and operating instructions
when using this product.
You should keep the safety and operating
instructions for future reference.
You should strictly follow all warnings provid-
ed on the product and listed in the operating
instructions.
Explanation of symbols
Double Insulated (Class II) Equipment. This
electrical appliance has been designed in
such a way that it does not require a safety
connection to electrical earth (ground).
This symbol indicates risks caused by high
voltages.
This symbol is to alert the user to other,
more specific risks.
This symbol indicates dangers caused by
the development of fire.
1.1
Installation
1.1.1
Placement
Place the unit on a stable, even surface.
Do not place this unit close to strong mag-
netic fields.
1.1.2 Cables
Lay the power cables so that they cannot
be damaged. The power cable may not be
kinked or laid over sharp edges, stood on or
exposed to chemicals; the latter also applies
to the system as a whole. A power cable
with damaged insulation can cause electric
shocks and poses a fire risk. As such, it must
be changed before the unit is used again.
1.1.3 Do not use this device near
water
The device should never be exposed to
water droplets or water splashes, such as
those found near a bathtub, wash basin,
kitchen sink, washing machine, wet base-
ment or swimming pool. Never place con-
tainers filled with liquids, such as e.g. flower
vases, on the device.
1.1.4 Ventilation
Slots and openings in the housing are used
to ventilate the device to ensure reliable
operation of the device and to protect the
device from overheating. Do not block the
ventilation holes. Install the device accord-
ing to the manufacturer's instructions. Nev-
er block the ventilation holes by placing the
device on a bed, sofa, rug, or similar soft
surfaces. This device should not be installed
in a bookshelf or built-in wardrobe unless
adequate ventilation is ensured.
1.1.5 Heat
Do not install the device near hot surfaces,
such as radiators, fan heaters, stoves or oth-
er devices (including amplifiers) that can be
hot. Never place objects with open flame,
such as candles or lanterns, on or near the
device. The installed batteries should not
be exposed to excessive heat such as direct
sunlight, fire or the like.
1.1.6 Accessories
Use only the accessories specified by the
manufacturer.
1.1.7 Network connection
Please make sure that the firewall function
is activated at your network access point
(router). Consult your router's instruction
manual.
1.2
Usage
1.2.1 Intended use
This device is intended exclusively for the re-
ception and playback of sound signals.
1.2.2 Remote control
Exposing the remote control sensor to direct
sunlight or high-frequency fluorescent light
may cause malfunction. In such cases, you
should move the system to a different loca-
tion to avoid such malfunction.
The supplied batteries are intended for func-
tional testing and may have a limited lifetime.
If the range of the remote control decreases,
replace the old batteries with new ones.
1.2.3 Overload
Never overload mains sockets, extension
cords or multiple sockets, otherwise there is
a risk of fire or electric shock.
1.2.4 Thunderstorm
The device should be disconnected from the
mains during thunderstorms and if it is not
used for a long time.
1.2.5 Penetration of foreign material
and liquid
Be careful not to allow foreign material or
liquid to enter this device through ventilation
holes, otherwise it may come into contact
with high voltage components or short cir-
cuit resulting in a fire or electric shock. Nev-
er spill liquids of any kind on this device.
1.2.6 Risks associated with high
volume
The device is not designed for listening with
headphones. To prevent possible hearing
damage, do not listen at high volume for
long periods.
1.2.7 Disconnection from power
supply
The power button does not completely dis-
connect the power supply in any position.
To completely disconnect the device from
the mains, unplug the mains cable from the
socket.
The mains plug must be easily accessible so
that the unit can be disconnected from the
mains at any time.
1.3
Maintenance
1.3.1 Device maintenance
Never attempt to carry out the maintenance
of this device yourself, because live parts
can be exposed through the openings or by
removing covers, contacting which can be
hazardous. Leave all maintenance to quali-
fied service personnel.
1.3.2 Clean only with a dry cloth!
Unplug the mains adapter of this device
from the mains socket before cleaning this
product. Never use liquid cleaning deter-
gents or cleaning sprays. Use only a damp
cloth for cleaning.
1.4
Batteries
Caution! Do not ingest battery!
The remote control supplied with this prod-
uct contains a coin cell battery. If the coin
cell battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead
to death.
Keep new and used batteries away from
children.
If the battery compartment does not close
securely, stop using the product and keep it
away from children.
If you think batteries might have been swal-
lowed or placed inside any part of the body,
seek immediate medical attention.
15