Loewe klang bar3 mr Guia Del Usuario página 18

Loewe klang bar3 mr

Main unit Components
3 Main unit components
3.1 Main unit front panel
1 (Standby) button/indicator– Switches the
soundbar on or switches to standby mode.
LED indicator colour information
LED colour Status
White Standby mode
Green Receiving PCM / AUX source
Blue Bluetooth mode
Turquoise Decoding Dolby Audio
Purple Decoding Dolby Atmos
Red Decoding DTS/DTS:X
Yellow USB mode / MP3 playback
Orange Play-Fi / Multiroom mode
2 (Source) button - Press to change input source.
Press and hold in standby mode to show the soft-
ware version on the display.
3 (Play/Pause) button - Play/pause audio track
from USB / Bluetooth / Play-Fi sources.
Press and hold to activate the pairing function in
Bluetooth mode or disconnect the existing paired
Bluetooth device.
3.2 Main unit rear panel
1 Rear flap – You will need to remove the rear flap
of your soundbar before using external speaker
switches.
2 External speaker switches - Use these switches
to connect additional external speakers as SUB /
REAR / FRONT / CENTRE channel. Set the switch
to SMALL for small speakers, LARGE for large
speakers. To disable the speaker for a specific
channel, set the switch to OFF.
3 PAIRING button - for pairing with external wireless
speakers.
4 WPS (Wi-Fi Protected Setup)
dicator – triggers Wi-Fi setup for Play-Fi.
Press and hold the button for 3 seconds to activate
the WPS mode.
LED indicator state Status
Wi-Fi Access Point (AP)
LED slowly pulsing
mode
Wi-Fi Protected Setup
LED flashes twice
(WPS) mode
Connected
LED is on
successful
Press and hold the button for 8 seconds to acti-
vate the AP mode.
5 6x cinch output – for external amplifier or active
speakers.
6 AUX IN – connect to the audio source via 3.5mm
audio cable.
7 OPTICAL – connect to the digital (optical) output
of an external device.
8 USB – connect a USB storage device.
18
Press and hold for 8 seconds in standby
mode to restore the factory settings.
4 -/+ (Volume) button – Reduces/increases the
volume level.
Press both buttons simultaneous-
ly to mute / unmute the soundbar.
2
button/in-
9 HDMI OUT (TV eARC/ARC) – connect to the HDMI
ARC/eARC jack on a TV.
10 HDMI-IN 1 / HDMI-IN 2 – connect to the HDMI out-
put of an external devices (e.g. game consoles, DVD
/ Pairing
and Blu-ray players).
11 12V trigger - wake up a connected AVR/amplifier
or active speaker system from standby when the
soundbar is turned on.
Warning
Do not connect the headphones to the 12V trig-
ger! Do not connect any external device that does
not support the 12V trigger function, otherwise
you may damage or destroy the device!
12 AC IN – connect to the power supply.
1 2
5
6
5 Front panel display
6 Remote control sensor - Point the remote control at
the remote control sensor to operate the system.
3
4
1
5 6 7 8 9
3 4
10 11 12