Chicco goody pro Manual De Instrucciones página 13

• Do not use this product if any part
is broken, torn or missing.
• This configuration should not be
used as a replacement for a cot
or bed. Should your child need to
sleep, then they should be placed
in a suitable pram body, cot or bed.
• Before assembling, ensure that the
product and its components have
not been damaged during trans-
portation. In this case, do not use
and keep out of reach of children.
• During adjustment operations, en-
sure that the moving parts of the
stroller do not come into contact
with your child.
• Make sure that the person using
the stroller knows how to operate
it in the safest way.
• This product must only be used by
an adult.
• The product must only be assem-
bled by an adult.
• To avoid all strangulation hazards,
never give children objects with
cords or strings attached, or leave
them close to such objects.
• Never use the stroller on staircases
or escalators: you could suddenly
lose control of it.
• Always pay attention when going
up and down steps or pavements.
• If the stroller is left exposed to di-
rect sunlight for an extended pe-
riod of time, allow it to cool down
before placing your child inside.
Prolonged exposure to direct sun-
light may cause the colour of the
materials and fabric to fade.
• Prevent the stroller from coming
into contact with salt water. It may
cause rusting.
• Do not use the stroller on the beach.
• When not in use, the stroller should
be kept out of reach of children.
TIPS FOR CLEANING AND MAINTENANCE
This product requires periodical maintenance. Cleaning and
maintenance should only be carried out by an adult.
CLEANING
The seat of the stroller can be removed (please see the section
FITTING AND REMOVING THE STROLLER LINING), and the re-
ducer cushion is removable as well. Clean the fabric parts using
a wet terrycloth and neutral soap. Periodically wipe the plastic
parts clean with a soft damp cloth. To prevent the formation
of rust, always dry metal parts if they have come into contact
with water.
The washing symbols and relative meanings are indicated be-
low:
Hand wash
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
MAINTENANCE
If necessary, lubricate the moving parts with dry silicone lubri-
cant.
Regularly check the condition of the wheels and clean off all
dust and sand. To avoid friction that may compromise the cor-
rect functioning of the stroller, make sure all plastic parts that
run along the metal tubes are clean of dust, dirt and sand.
Keep the stroller in a dry place.
GENERAL INSTRUCTIONS
OPENING THE STROLLER AND FIRST ASSEMBLY
WARNING: When opening the stroller, make sure that your
child or other children are at a safety distance.
WARNING: Make sure that during these operations the mov-
ing parts of the stroller do not come into contact with your
child.
1. Grip the handle (Fig. 1) and pull upwards (Fig. 1A) until the
structure opens fully (Fig. 1B).
WARNING: Before use, ensure that the stroller is locked in
the open position, checking that the mechanism is effectively
locked.
2. Assemble the rear wheels by inserting the pin of the wheel
into the appropriate hole located on the rear tube, until it
locks in place (Fig. 2). To remove them, use the button locat-
ed on each wheel (Fig. 2A).
WARNING: Before use, ensure that the wheels have locked
correctly.
3. Install the bumper bar by inserting it into the appropriate
slots located on the joints of the stroller (Fig. 3). Should you
need to remove it, press the buttons on both sides (Fig. 3A).
WARNING: Never use the bumper bar to lift the product with
your child sitting in it.
CARRY-ALL BASKET
The storage basket is already installed. Should you need to re-
13