Chicco goody pro Manual De Instrucciones página 14

move it, follow the steps outlined below.
4. The storage basket is attached to the frame at several points.
Unsnap the 2 buttons located on the rear of the basket (Fig.
4); remove the lateral straps on the rear legs of the stroller
(Fig. 4A); unsnap the buttons present under the seat (Fig. 4B);
open the velcro straps on the front under the footrest (Fig.
4C).
To reassemble the basket follow the same steps backwards.
HOW TO USE THE SAFETY HARNESS
This stroller has a five-point safety harness featuring two shoul-
der straps, two adjustment holes, a waist strap and a crotch
strap with buckle.
5. WARNING: To use it with children from birth to approx. 6
months of age, you must use the shoulder straps, first thread-
ing them through two adjusting holes (Fig. 5), and threading
the waist strap through the vertical holes (Fig. 5A).
The height of the shoulder straps can be adjusted by using the
different slots found on the backrest.
6. After laying the child in the stroller, fasten the straps (Fig. 6) by
passing first the two forks (A) inside the shoulder strap buck-
le (B) and then inside the crotch strap buckle (C); adjust the
height of the shoulder straps so that they correctly fit your
child's shoulders (Fig. 6A).
Always make sure that the straps are fastened correctly. To un-
fasten the strap, press and pull the side prongs.
WARNING: To guarantee the safety of your child, the safety
harness must be fastened at all times.
To make sure that the belts are fastened properly to the anchor-
ing points, after placing your child inside the stroller, pull the
end parts of the belts firmly.
ADJUSTING THE BACKREST
The backrest can be adjusted to 3 positions.
7. To lower the backrest, lift the adjusting handle located on the
rear of the backrest (Fig. 7). To raise the backrest, simply lift it
to the desired position.
WARNING: The child's weight can make these operations
more difficult.
REAR BRAKES
The rear wheels have linked brakes, which can be applied si-
multaneously on both rear wheels by using the support tube.
8. To activate the brakes, press down on the pedal located cen-
trally (Fig. 8). To release the brakes, press the pedal in the op-
posite direction (Fig. 8A).
SUN CANOPY
The hood is already installed on the stroller.
9. To open and adjust the canopy use the front arch (Fig. 9). The
hood can be extended by opening the zipper (Fig. 9A-9B). Fix
the back of the hood onto the backrest using the two snap
fasteners (Fig. 9C) and the velcro fasteners on the sides (Fig.
9D). Should you wish to remove the canopy from the stroller,
open the zip wrapped around the tube above the backrest
(Fig. 9E) and, using a sharp object as a lever, lift the plastic
component indicated while at the same time pulling up on
the metal rod (Fig. 9F). Complete the operation by undoing
the two buttons on the back of the backrest. Lift the fabric
flap on the first segment (Fig. 9G) to access the mesh section
for the summer months.
ADJUSTABLE LEGREST
The legrest can be used in 2 positions.
10. To use the legrest in the horizontal position simply push it
upwards. To lower it, use the button located under the leg-
rest (Fig. 10).
FITTING AND REMOVING THE STROLLER LINING
To remove the lining from the seat, follow the steps below:
11. Detach all the velcro fasteners and snap buttons that con-
nect the backrest to the hood (Fig. 11A) and remove the
straps on both sides from the plastic hooks that attach the
backrest to the handle of the frame (Fig. 11B).
12. On the sides of the seat, remove the velcro fasteners (Fig.
12) and slip the fabric tab out from the plastic ring on the
frame (Fig. 12A). Complete this operation for both sides of
the stroller.
13. Remove the textile part of the legrest from the frame (Fig.
13) and then the elastic strap (Fig. 13A). Remove the velcro
on the elastic strap, located under the seat, and remove the
strap from the buckle (Fig. 13B). Remove the pocket from
the adjustment button for the backrest and pull all the fab-
ric upwards (Fig. 13C - 13D).
To put the lining back on the stroller follow the same steps
backwards.
FOLDING THE STROLLER
WARNING: When opening or closing the stroller, make sure
that your child or other children are at a safe distance.
Make sure that during these operations the moving parts of the
stroller do not come into contact with your child.
Before closing the stroller, ensure that the storage basket is
empty.
The stroller has a closing device that can be used with one
hand.
14. To close the stroller, push switch "A" to the left and simulta-
neously press button "B" (Fig. 14); push down on the han-
dle and the stroller will close automatically. The stroller will
automatically lock in the closed position. When closed, the
stroller stands up on its own (Fig. 14 A-B). To make the stroll-
er even more compact when closed, the bumper bar can be
turned towards the handle (Fig. 14C).
ACCESSORIES
WARNING: The accessories described below may not be in-
cluded in some product versions. Carefully read the instruc-
tions for the accessories that came with the model you have
purchased.
SHOULDER STRAPS AND CROTCH STRAPS
The stroller is fitted with padded shoulder straps and a soft
crotch strap to ensure the safety and comfort of your child.
15. For assembly, insert the shoulder straps (Fig. 15) and the
crotch strap in the relevant padding (Fig. 15A).
WARNING: Adjust the waist belt if necessary by pressing on
the buckles.
WARNING: To guarantee the safety of your child, the safety
harness must always be fastened.
RAIN COVER
16. To fit the rain cover, fasten the straps around the stroller's
frame in the positions shown in Fig. 16 (steps to be repeated
on both sides of the stroller).
When you have finished using the rain cover, allow it to dry
properly if it is wet.
WARNING: The rain cover cannot be used on the stroller with-
out the hood being extended, as it may cause suffocation.
WARNING: When the rain cover is fitted on the stroller, never
leave it exposed to direct sunlight with your child inside, as the
temperature will rise considerably.
USING THE CAR SEAT ON THE STROLLER
The following elements, which can be purchased separately,
can be used with the Good Pro stroller:
14