Publicidad
Idiomas disponibles
Idiomas disponibles
cavities. Always unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
attempt to open the battery pack for any reason. If the plastic housing of the battery pack
WARNING:
breaks or cracks, return to a service center for recycling.
INSTALLING AND REMOVING THE BATTERY PACK FROM THE TOOL
WARNING: Make certain the lock-off button is engaged to prevent switch actuation
before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack into tool
until an audible click is heard as shown in figure 3.
TO REMOVE BATTERY PACK: Depress the battery
release buttons as shown in figure 4 and pull battery pack
out of tool.
Sanding in extremely tight areas otherwise difficult to reach and require hand sanding.
Detail Sanding
Select a high oscillating frequency. Sand with continuous motion and light pressure.
Applying excessive pressure does not increase material removal; but will prematurely
wear sanding sheets.
Remove excess wood from door jamb, window sill and/or toe kick. Removing excess
Flush Cutting
copper or PVC pipe.
Carpets & backing, old tile adhesives, caulking on masonry, wood and other surfaces.
Removal Work
Tile grout, plaster, mortar splatters, concrete on tiles, sills.
Removal of Excess Materials
New floors and tiles.
Preparation of Surfaces
Shock hazard. Do not allow any liquid to get inside charger.Never
SAVE THESE INSTRUCTIONS
INTENDED USE
10
3
4
Publicidad
