Kärcher WV 6 Plus D500 Manual De Instrucciones página 13

Cleaning the squeegee blade
and suction nozzle
1. Switch off the device.
2. Press the unlocking button at the
bottom of the suction nozzle and pull
the suction nozzle off the device.
3. Press the unlocking button at the top
of the suction nozzle and slide the
clamping rail off the suction nozzle.
4. Pull the squeegee blade sideways
out of the suction nozzle.
5. Clean the squeegee blade, suction
nozzle and clamping rail under run-
ning water.
Downloaded from manualsnet.com
English
search engine
6. Push the squeegee blade into the
suction nozzle after drying.
7. Place the clamping rail on the
squeegee blade and push it to the
rear until it audibly latches into the
suction nozzle. Make sure that the
clamping rail slides correctly into the
side of the guides on the suction
nozzle.
Troubleshooting guide
Malfunctions often have simple causes
that you can remedy yourself using the
following overview. When in doubt, or
in the case of malfunctions not men-
tioned here, please contact your autho-
rized Customer Service.
With increasing aging, the capacity of
the battery will decrease even with
good care, so that even when fully
charged, the full run time is no longer
achieved. This is not a defect.
The device is not working
The battery is not fully charged.
 Charge the battery.
The device is defective.
13